Elastic E-Collar Assembly Instructions

Thank you for choosing K9 Tactical Gear for your Elastic E-Collar Holder! Please swipe left to right and follow the directions below to assemble or adjust your E-Collar Holder.

files/step_1_fb39c3ea-6de0-4b01-942e-e69dd3f5eea4.png

Step 1

Remove all components from packaging or from existing strap.

files/Step_2_4870a537-e5fb-4b7a-a091-36f3d9c5e534.png

Step 2

Feed webbing up, across, and back down through the slots on both sides of the receiver. Receiver should be placed close to the 'rectangle' end of assembly with prongs on the same side as the product tag. Note: This e-collar holder is incompatible with the Dogtra 1900s and ARC.

files/Step_3_f161449d-5437-4c22-b5a3-5e0b51a6dc87.png

STEP 3

Feed slide adjuster onto webbing first up through a slot, over middle bar, and back down opposing slot. Set this slide adjuster closer to receiver for smaller dogs or further away from receiver for larger dogs.

files/Step_4_ea0dcb18-4b55-4645-b95c-51b6d9c04a99.png

STEP 4

Slide elastic band over webbing to rest a few inches from the slide adjuster.

files/Step_5_d70df4c8-2047-4db8-82ee-bcb90a0bd557.png

STEP 5

Disconnect Cobra Buckle and feed webbing through bottom slot on the male end/underneath silver sliding bar.

files/Step_6_b7a2104c-3e11-4e50-87dd-0582b164ae40.png

STEP 6

Loop webbing over the top of the silver sliding bar and through buckle, then back through elastic band.

files/Step_7_39dff0f6-6fc2-4cb2-a139-17583c71e476.png

STEP 7

Feed webbing back through slide just as in 3, but now in the opposite direction.

files/step_8_final_68ca4a30-9332-4267-814c-ee7b9c74a105.png

STEP 8

You may test fit and adjust the collar during this step if needed. Bring slide adjuster and male end of cobra closer to receiver for tighter fit or further away from receiver for looser fit.

files/Step_9_d033f8f8-1b4e-4765-a4cb-2902f75a079b.png

STEP 9

Loop webbing back over and feed through slide adjuster before feeding remaining loose webbing through elastic band.